Abstract  To understand the basolateral p-aminohippurate (PAH) transporter in the S3 segment of rabbit proximal tubules and its relationship to the transporter in the S2 segment, we measured the 30-s uptake and efflux of PAH across the basolateral membrane of single isolated S3 segments at 37 degrees C in bicarbonate-buffered media. Kinetic analysis of uptake data revealed a concentration of PAH at one-half Jmax of approximately 107 microM (same as in the S2 segment) but a Jmax of 600 fmol.min-1.nl-1 (one-tenth that of S2 segment). The coefficient for efflux across the basolateral membrane was also only one-sixth to one-tenth of that in the S2 segment. These data suggest that the basolateral PAH transporter is the same in both segments but that there are fewer transporters in the S3 than in the S2 segment. However, the apparent inhibitor constant values for cis-inhibition by probenecid (approximately 29 microM in S3, approximately 15 microM in S2) and by alpha-ketoglutarate (alpha-KG) in the presence of LiCl (approximately 40 microM in S3, approximately 160 microM in S2) suggest that the transporters may not be identical in the two segments. In bicarbonate-buffered medium, preloading the tubules with 100 microM alpha-KG did not trans-stimulate PAH uptake across the basolateral membrane, whereas preloading with 1.0 microM alpha-KG caused a significant stimulation of 43%. However, in N-2-hydroxyethylpiperazine-N'-2-ethanesulfonic acid-buffered medium, preloading the tubules with 100 microM alpha-KG caused a twofold increase in PAH uptake.(ABSTRACT TRUNCATED AT 250 WORDS)

Abstract  We explore the potential of xerogel composites to tailor the behavior of active dopants that are sequestered within the xerogel. Toward this end, we report on the local dipolarity and dynamics of two fluorescent probes (pyrene and rhodamine 6G, R6G) each co-doped at low concentration directly into a series of binary xerogel composites. The composites that we have investigated are composed of tetraethylorthosilicate (Si(OCH2CH3)(4),TEOS) plus one of several organically-modified silanes (ORMOSILs), organic oligomers, or a common surfactant. For convenience we divide these xerogel composites into two classes: (1) xerogels wherein the organic character arises from the addition of an ORMOSIL co-monomer, possessing a non-hydrolyzable organic functional group, that becomes covalently incorporated with in the xerogel and (2) xerogels wherein the organic content is adjusted by adding organic oligomers or a surfactant. Six organically-modified silylalkoxides of the form R' Si-n(OR)(4-n) were investigated as ORMOSILs. Poly(ethylene glycol), Nafion, and Ionene 6,2 were tested as oligomers. Triton X-100 was used as the surfactant. To estimate the local dipolarity within these composites we used the static fluorescence from pyrene molecules that were sequestered within the composites. These experiments showed that the local dipolarity surrounding the average pyrene molecule can be tuned significantly, but this depends on the actual organic species that one uses to prepare the xerogel composite. Time-resolved fluorescence anisotropy measurements were used to quantify the R6G mobility within the same composites. These results demonstrate that certain organic additive scan be used to adjust the R6G mobility within the xerogel composite.

Abstract  An amperometric needle-type electrochemical glucose sensor intended for tear glucose measurements is described and employed in conjunction with a 0.84 mm i.d. capillary tube to collect microliter volumes of tear fluid. The sensor is based on immobilizing glucose oxidase on a 0.25 mm o.d. platinum/iridium (Pt/Ir) wire and anodically detecting the liberated hydrogen peroxide from the enzymatic reaction. Inner layers of Nafion and an electropolymerized film of 1,3-diaminobenzene/resorcinol greatly enhance the selectivity for glucose over potential interferences in tear fluid, including ascorbic acid and uric acid. Further, the new sensor is optimized to achieve very low detection limits of 1.5 ± 0.4 μM of glucose (S/N = 3) that is required to monitor glucose levels in tear fluid with a glucose sensitivity of 0.032 ± 0.02 nA/μM (n = 6). Only 4-5 μL of tear fluid in the capillary tube is required when the needle sensor is inserted into the capillary. The glucose sensor was employed to measure tear glucose levels in anesthetized rabbits over an 8 h period while also measuring the blood glucose values. A strong correlation between tear and blood glucose levels was found, suggesting that measurement of tear glucose is a potential noninvasive substitute for blood glucose measurements, and the new sensor configuration could aid in conducting further research in this direction.

Abstract  Native muscadines (Vitis rotundifolia Michx.) are dioecious, but muscadine vineyards are usually planted with a mixture of female plants and hermaphroditic pollenizers. Hermaphroditic cultivars are derived from either of two separate sources original hermaphroditic plants, H1 or H2. Nine hermaphroditic and two female cultivars were studied to determine their potential as pollenizers. Inflorescences of each cultivar were collected in the field to evaluite the number of anthers per flower, the number of pollen grains per anther, and pollen viability and germination in the main and secondary flowering periods. The number of flower clusters per shoot ranged from one to four with most producing two or three flower clusters per shoot. The number of anthers per flower varied by cultivar and cluster position, but in general was between six and eight anthers per flower. 'Noble' showed the highest pollen grains production per anther and per flower, reaching 5777 and 39,860, respectively, in the first cluster and 'Carlos' produced the least amount of pollen. All cultivars that had secondary flowering showed lower pollen production per anther and per flower as compared with the main flowering period. Optimal muscadine pollen germination media contained 50 mg.L-1 boric acid, 145 mg.L-1 calcium nitrate, 188 g.L-1 sucrose, 10 g.L-1 agar, and 10 mM 2-(N-morpholino)ethanesulfonic acid (MES) pH 6.0. The pollen grain viability of hermaphroditic and female cultivars was high, but pollen grain germination was low in hermaphroditic cultivars and absent in female cultivars. H1-derived cultivars produced more flower buds per cluster and higher germination rates than H2-derived cultivars, indicating they may be better pollenizers. Chemical names used: 2-(N-morpholino)ethanesulfonic acid (MES).

Abstract  We report on the characterization, assembly and electroanalytical performance of Prussian blue/polypyrrole (PBPPy) composite nanoparticles synthesized by the reverse micelle method. Scanning electron microscopy suggests the formation of nanosized PBPPy particles with diameters between 40 and 50 nm. Optical absorption confirms that the particles are composed of Prussian blue (PB) and polypyrrole. PB and PBPPy nanoparticles were anchored onto the surface of cysteine-modified Au electrodes. Cyclic voltammetry experiments show that PB- or PBPPy-modified electrodes exhibit intrinsic electrochemical properties and a high electrocatalytic activity towards H2O2. PBPPy-modified electrodes exhibit a higher sensitivity to H2O2 than PB-modified electrodes. A linear calibration curve in the concentration range 0.99 μM-8.26 mM H2O2 is constructed with a detection limit of 0.23 μM at a signal-to-noise ratio of 3. Excellent stability is observed for PBPPy-composite-nanoparticle-modified electrodes even in a pH 6 phosphate buffer solution with a high H2O2 concentration (0.99 mM). Glutaraldehyde and [Formula: see text] were also employed to immobilize glucose oxidase for the development of PBPPy-based biosensors. The results show that PBPPy composite nanoparticles can be used to develop oxidase-based biosensors.

Abstract  N-2-hydroxyethylpiperazine-N'-2-ethanesulfonic acid (HEPES) has been shown to cause changes in cultured endothelial cells and smooth muscle function at concentrations from 5 to 25 mM. To determine whether HEPES also affects vascular permeability, the effects of two buffers, HEPES and phosphate, were compared in isolated perfused rabbit lungs. Hemodynamic parameters and vascular protein permeability-surface area products (PS) were measured after perfusion with the buffers. Endothelial permeability was measured for an anionic and a cationic albumin to assess the charge effects of the zwitterion buffer. With HEPES, there were no changes in vascular pressure or resistance but permeability was affected. Cationic albumin permeability increased with 12 mM HEPES (8.7phosphate-->30(12) mM HEPES x ml.min-1.g dry lung-1 x 10(-2)) as did the anionic albumin PS (2.7phosphate-->3.52(12) mM HEPES). The cationic PS returned to baseline (8.1(60) mM HEPES) at 60 mM HEPES, but the anionic PS did not change from the 12 mM HEPES (4.01(60) mM HEPES). In summary, we find that HEPES is not innocuous. Although hemodynamic parameters did not change, endothelial permeability was increased when HEPES was used at normal concentrations. Therefore, HEPES should be used with caution as a physiological buffer in perfused organ systems.

Abstract  Through the years, scientists have developed cutting-edge technologies to make (bio)sensors more convenient for environmental analytical purposes. Technological advancements in the fields of material science, rational design, microfluidics, and sensor printing, have radically shaped biosensor technology, which is even more evident in the continuous development of sensing systems for the monitoring of hazardous chemicals. These efforts will be crucial in solving some of the problems constraining biosensors to reach real environmental applications, such as continuous analyses in field by means of multi-analyte portable devices. This review (with 203 refs.) covers the progress between 2010 and 2015 in the field of technologies enabling biosensor applications in environmental analysis, including i) printing technology, ii) nanomaterial technology, iii) nanomotors, iv) biomimetic design, and (v) microfluidics. Next section describes futuristic cutting-edge technologies that are gaining momentum in recent years, which furnish highly innovative aspects to biosensing devices.

Abstract  To characterize H+ transport mechanisms in a fresh suspension of rat medullary thick ascending limb (MTAL) tubules, we have monitored intracellular pH (pHi) with use of the fluorescent probe 2',7'-bis(carboxyethyl)-5,6-carboxyfluorescein. First, a Na(+)-H+ antiporter was identified in bicarbonate-free N-2-hydroxyethylpiperazine-N'-2-ethanesulfonic acid (HEPES)-buffered media at 25 degrees C. pHi recovery of Na-depleted acidified cells was dependent on extracellular sodium concentration, which was inhibited by amiloride in a manner consistent with simple competitive interaction with one external transport site (amiloride Ki = 1.5-2.1 x 10(-5) M); Na-induced pHi recovery of acidified cells was electroneutral since it was not affected by 5 or 100 mM extracellular potassium in the presence or absence of valinomycin. Second, at 37 degrees C, pHi recovery after acute intracellular acidification caused by 40 mM acetate addition to cell suspension was inhibited 36% by 200-400 nM bafilomycin A1, a macrolide antibiotic that specifically inhibits vacuolar-type H(+)-ATPase at submicromolar concentrations. In addition, amiloride-insensitive pHi recovery was inhibited by bafilomycin A1, 10(-3) M N-ethylmaleimide, and 10(-4) M preactivated omeprazole but not by 10(-5) M vanadate, 10(-4) M SCH 28080, or removal of extracellular potassium. Also, metabolic inhibition by absence of substrate, 10(-4) M KCN, or 5 x 10(-4) M iodoacetic acid inhibited amiloride-insensitive pHi recovery. The inhibitory effects of absence of metabolic substrate and iodoacetic acid were removed by reexposure to glucose and L-leucine and by exogenous ATP, respectively.(ABSTRACT TRUNCATED AT 250 WORDS)

Abstract  Owing to the numerous benefits obtained when operating proton exchange membrane fuel cells at elevated temperature (>100 °C), the development of thermally stable proton exchange membranes that demonstrate conductivity under anhydrous conditions remains a significant goal for fuel cell technology. This paper presents composite membranes consisting of poly[2,2'-(m-phenylene)-5,5'-bibenzimidazole] (PBI4N) impregnated with a ZrO2 nanofiller of varying content (ranging from 0 to 22 wt %). The structure-property relationships of the acid-doped and undoped composite membranes have been studied using thermogravimetric analysis, differential scanning calorimetry, dynamic mechanical analysis, wide-angle X-ray scattering, infrared spectroscopy, and broadband electrical spectroscopy. Results indicate that the level of nanofiller has a significant effect on the membrane properties. From 0 to 8 wt %, the acid uptake as well as the thermal and mechanical properties of the membrane increase. As the nanofiller level is increased from 8 to 22 wt % the opposite effect is observed. At 185 °C, the ionic conductivity of [PBI4N(ZrO2 )0.231 ](H3 PO4 )13 is found to be 1.04×10(-1)  S cm(-1) . This renders membranes of this type promising candidates for use in high-temperature proton exchange membrane fuel cells.

Abstract  We have developed an implantable glucose sensor based on a new tri-layer membrane configuration. The needle-type sensor integrates a Pt working electrode and a Ag/AgCl reference electrode. Its size is equivalent to a 25 gauge needle (0.5 mm in diamater). Poly (o-phenylenediamine) was used as an inner coating to reduce interference by small compounds present in the body fluids, and the perfluorinated ionomer, Nafion as a biocompatible, protective, outer coating. Glucose oxidase trapped in an albumin/glutaraldehyde matrix was sandwiched between these coatings. In vitro tests in buffer showed the sensors had a good selectively, a sensitivity of about 25 nA/mM, and a 90% response time of 33 s. Stabilization of the current following polarization required 10 to 30 min in vitro and 30 to 40 in vivo. Although these sensors remained stable for many weeks in saline solution, their implantation in animals resulted in the degradation of the protective Nafion outer coating, which in turn, led to the failure of the incorporated reference electrode. We demonstrated that if unprotected, the AgCl layer of the reference electrode rapidly dissolves in the biological environment. However, we later showed that in vivo degradation of Nafion can be prevented by heat curing. When heat cured sensors were subcutaneously implanted in dogs, the sensors' signal closely followed the plasma glucose level during glucose tolerance tests. The response of the sensors implanted in dogs was retained for 10 days.